Zen Go Synergy Core
Released: (06.04.2021)
Zen Go Synergy Core FW 1.49 / Bundle 2.2.4:
New in Version 1.49:
- Added support for Diode609 – Class-A Compressor/Limiter
- Added support for NEU473A – VCA Compressor / Limiter
Improvements & Fixes in Version 1.49:
- Updated display settings that produced noise in some scenarios when the display is set to less than 100% brightness.
- Fixed АuraVerb not passing a signal on the 2nd headphone output
- Fixed AuraVerb losing its last stored settings after the panel is shut down
- Fixed a problem with the Darkface Amp/Cab that produces a different sound when used with pre-amp 1 & pre-amp 2
- Fixed incorrect representation on the display when clock source is changed from USB to S/PDIF
- Fixed FX strip channels 3-4 which were not processing audio when signal is sent
to DAW
- Improved stability & performance of core system components
Zen Go Synergy Core Control Panel 1.1.6 / Bundle 2.2.4:
New in Version 1.1.6:
- Added support for Diode609 – Class-A Stereo Compressor/Limiter
- Added support for NEU473A – VCA Compressor / Limiter
Improvements & Fixes in Version 1.1.6:
- Fixed wrong behavior where software control panel, peak meters indicate signal after you cycle the menus without playback being present
- Fixed wrong behavior of software peak meters in DAW I/O/From Daw section, which were not registering signals correctly
- Fixed mic emulations images not loading correctly in cases where emulations unlock code is not assigned for the type of mic
Additional information:
- Please, make sure to back up and save your setting before the update!
- The update will not erase any settings from your device.
- Perform a factory reset from the device hardware ones the update is completed if you experience any performance related issues
- Unplug the USB cable
- Hold down [Gain + Hp/Mon] buttons
- Plug the USB cable again and release the buttons.